North America's Place To Buy New & Refurbished Telephone Equipment! Norstar  Meridian Startalk Flash CallPilot 100 Voice Mail Norstar M7310 M7324 M7208 T7208 T7316 & Accessories! 

Date & Time Programming

There are a couple of different ways access the time change feature, depending on the type of system you have.  A programming template is provided below if you need it.   Just cut-out the middle areas as well as around the outside of the template.   Once cut, place the template over the top 2 rows of buttons on your 7310 or 7324 telephone (typically lines 1 and 2 on your telephone), or the 8 rows on your 7208 telephone.

After you enter programming mode, all methods are pretty much the same.

****** IMPORTANT NOTES ******
*** The 308 and 616 KSU can be programmed with any style Norstar telephone.

*** The M8x24, Compact ICS and the Modular ICS KSU must be programmed with an M7310, T7316 or a M7324 telephone. (A M7208/T7208 will not program these systems.)

For Nortel BCM, please click on this link

Note CICS & MICS 2007 DST adjustment: Set Daylight Savings Time = Y in "System Programming"

Access type 1:   Press  * * TIME (8463)  or

Access type 2:   Press  * * ADMIN (23646)

Screen displays Password: then enter 23646 or 266344

Display shows 1.Sys speed dial

Press Next Display shows 2. Names

Press Next Display shows 3. Time and date

Press Show Display shows Time 16:24

On the Softkey under the display it says CHANGE

If you wish to change the time, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour displays;

If you wish to change the hour, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the hour is erased allowing you to enter the new time - enter the new hour in 24 hour format, when OK press NEXT

Once you pressed the NEXT button the minutes display;

If you wish to change the minutes, press CHANGE, if not press NEXT

Once you pressed the CHANGE button the minutes are erased allowing you to enter the new time - enter the new minutes, when OK press NEXT

Follow the same procedure for changing the date!

   Programming template for M7208

Programming template for M7310

Print this page, cut out the middle areas with a utility knife and then cut around the outside box.  After you're done cutting, place the template over the top 2 rows on your M7310 or M7324 telephone or the 8 rows on your M7208 telephone.

Please click here to go to our programming support page if you are still having difficulties!

 NOTE: Alpha Telecom Services Inc places this programming instructions on our web page only as a courtesy.
Alpha Telecom Services Inc takes no responsibility for any programming problems that you may incur while using these programming procedures.
*** It is always recommended that you have a Norstar programming specialist to program your telephone system.

Please click the back button to return to the previous page.

To inquire via phone, call

905-204-6970

9:00am to 6:00pm EST